Line

Top  Previous  Next

clip0063

 

Create a line between 2 points.

 

The line is placed on the current UCS.

 

When creating  objects  we can :

 

Input a number to  fix the size :  eg  10 will fix the line length to 10 units

Input a < (minus)  followed by a number to fix the angle : eg a <25  will constrain the line to have 25 degrees angle to the current UCS X-Axis

Keep and Hold down the shift key  to contrain Ortho mode :  the line will be parallel to the UCS X-Y axis

 

The 2 end points can be inserted by coordinates at the command input prompt. Valid inputs are :

 

5 , 5 ,  6        :  Point in UCS  coordinates

5 , 6                :  Point  in UCS coordinates ( Z ==0 )

r 5 , 4 , 5        :  Relative input  in UCS coordinates        

r 5 , 4                :  Relative input  in UCS coordinates (Z==0 )        

w 3 , 5 , 6        :  World point