Create a rectangle.
Select creation method at the command prompt:
Center Vertex : Create a rectangle by center point and upper vertex point
Corners : Create a rectangle by corner points
By side : Create a rectangle by side
The 2 end points can be inserted by coordinates at the command input prompt. Valid inputs are :
5 , 5 , 6 : Point in UCS coordinates
5 , 6 : Point in UCS coordinates ( Z ==0 )
r 5 , 4 , 5 : Relative input in UCS coordinates
r 5 , 4 : Relative input in UCS coordinates (Z==0 )
w 3 , 5 , 6 : World point